Fix possible traceback if certificate is not available on page load
Description
Problem/Justification
Impact
is cloned by
SmartDraw Connector
Katalon Manual Tests (BETA)
Activity
Joe Miller November 21, 2019 at 7:59 PM
Got it. Thank you. I may need to be educated on what a PR is.
Erin Clark November 21, 2019 at 6:26 PM
Erin Clark November 21, 2019 at 6:23 PM
So I think what is happening is that the traceback is causing the ipv6 to never get populated, it is supposed to have a default :: wildcard ip in there for you to select and save with, I will create a PR to try to fix that for you.
Joe Miller November 21, 2019 at 1:03 AM
I had never set up any certificate before. When I updated to 11.3-Beta an error appeared in the alerts list. So, I was looking into what it would take to add a certificate when I found this page in this state.
I have since created a certificate. But, I can't add it to this page because I don't have an ipv6 address to select in that field (and thus turn on the save button).
While setting up this new certificate (not completely sure I did it correctly) I did notice that there was some pre-built cert listed (freenas_default). Maybe the system is supposed to use that if no custom cert is created?
Erin Clark November 20, 2019 at 9:29 PM
So I think it is tracing back on certificate, do you not have a certificate setup on your box at all?
Details
Details
Assignee
Erin ClarkReporter
Joe MillerComponents
Fix versions
Affects versions
Priority
Low
More fields
Time tracking
More fields
Time trackingKatalon Platform
Linked Test Cases, Katalon Defect Results, Katalon Studio Test Results
Katalon Platform
In the System > General settings, I am unable to save a new config because the required fields are not filled in. (I was going there because I wanted to address a missing HTTPS cert error. see image).
The problem is that the ipv6 field appears to not have any options listed. So, I can't fill in the requirements to turn the save button on. (see image)
I have ipv6 turned off on my router. But, it seems like FreeNAS should operate without ipv6 and allow updating the https cert, etc. Please let me know if ipv6 on is a requirement.